Analytical Force Modeling of Fixed Abrasive Diamond Wire Saw Machining With Application to SiC Monocrystal Wafer Processing
At a Glance
Section titled āAt a Glanceā| Metadata | Details |
|---|---|
| Publication Date | 2016-09-22 |
| Journal | Journal of Manufacturing Science and Engineering |
| Authors | Shujuan Li, Aofei Tang, Yong Liu, Jiabin Wang, Dan Cui |
| Institutions | Xiāan University of Technology, Missouri University of Science and Technology |
| Citations | 40 |
Abstract
Section titled āAbstractāFree abrasive diamond wire saw machining is often used to cut hard and brittle materials, especially for wafers in the semiconductor and optoelectronics industries. Wire saws, both free and fixed abrasive, have excellent flexibility, as compared to inner circular saws, outer saws, and ribbon saws, as they produce a narrower kerf, lower cutting forces, and less material waste. However, fixed abrasive wire saw machining is being considered more and more due to its potential for increased productivity and the fact that it is more environmentally friendly as it does not use special coolants that must be carefully disposed. The cutting forces generated during the wire saw process strongly affect the quality of the produced parts. However, the relationship between these forces and the process parameters has only been explored qualitatively. Based on analyzing the forces generated from the chip formation and friction of a single abrasive, this study derives an analytical cutting force model for the wire saw machining process. The analytical model explains qualitative observations seen in the literature describing the relationship between the cutting forces and the wafer feed rate, wire velocity, and contact length between the wire and wafer. Extensive experimental work is conducted to validate the analytical force model. Silicon carbide (SiC) monocrystal, which is employed extensively in the fields of microelectronics and optoelectronics and is known to be particularly challenging to process due to its extremely high hardness and brittleness, is used as the material in these experimental studies. The results show that the analytical force model can predict the cutting forces when wire saw machining SiC monocrystal wafers with average errors between the experimental and predicted normal and tangential forces of 9.98% and 12.1%, respectively.
Tech Support
Section titled āTech SupportāOriginal Source
Section titled āOriginal SourceāReferences
Section titled āReferencesā- 2004 - Fixed Abrasive Diamond Wire Saw Slicing of Single-Crystal Silicon Carbide Wafers [Crossref]
- 2006 - Theoretical Analysis on the Effects of Crystal Anisotropy on Wire Sawing Process and Application to Wafer Slicing [Crossref]
- 2011 - Ultra-Precision Dicing and Wire Sawing of Silicon Carbide (SiC) [Crossref]
- 2009 - Modeling the Tensile Strength and Crack Length of Wire-Sawn Silicon Wafers [Crossref]
- 2012 - Effect of Tensile Properties on the Abrasive Wear of Steel Saw Wires Used for Silicon Ingot Slicing [Crossref]
- 2012 - Analysis of Ductile Mode and Brittle Transition of AFM Nanomachining of Silicon [Crossref]
- 2002 - Brittle-Ductile Transition in the Diamond Cutting of Glasses With the Aid of Ultrasonic Vibration [Crossref]
- 2005 - Ductile Regime Nanomachining of Single-Crystal Silicon Carbide [Crossref]
- 2011 - Ductile Regime Single Point Diamond Turning of Quartz Resulting in an Improved and Damage-Free Surface [Crossref]
- 2011 - Abrasive Electrochemical Multi-Wire Slicing of Solar Silicon Ingots Into Wafers [Crossref]