Bounding Non-Thermal Mechanical Transients during Macroscopic Decoherence - A Levitated Optomechanics Protocol
Paper details
Section titled “Paper details”| Field | Value |
|---|---|
| Journal | Zenodo (CERN European Organization for Nuclear Research) |
| Published | 2026-04-25 |
| Authors | Riam Daou |
| DOI | 10.5281/zenodo.19760878 |
Under the Mass-Energy-Information Equivalence Principle, the proposed protocol predicts a mass-equivalent defect of 3.18 × 10^-38 kg for each erased entangled bit. At N = 10^15, the predicted defect is at least 3.18 × 10^-23 kg and should produce a frequency shift near 0.16 μHz on a timescale below 1 μs. The paper presents these values as protocol calculations, not measurements. It also defines a sealed-system control, where retained Landauer heat should enforce ΔM = 0. The experiment would seek ΔM < 0 after controlling trap stiffness, thermal expansion, polarizability drift, and photon recoil.
NV centers as the information register
Section titled “NV centers as the information register”The proposed information register is a synthetic silica nanosphere with a radius of about 250 nm. A highly milled nanodiamond core inside it contains a dense network of nitrogen-vacancy centers. Each center’s electron spin serves as a qubit, and magnetic dipole-dipole coupling is the stated mechanism for entangling N centers. The joint state uses the tensor product of the single-center Hilbert spaces. A uniform microwave π/2 pulse drives the ensemble into a synchronized superposition. The authors assign this pure coherent state a structural information capacity of N bits. The paper uses the maximum von Neumann entropy of the synchronized state as its information-capacity measure.
Decoherence follows a randomized microwave noise pulse, which erases accessible phase coherence in the measured subsystem. Landauer’s minimum erasure work is W ≥ kBT ln 2. At 300 K, the authors use E = mc² to convert that work into 3.18 × 10^-38 kg per bit. The cumulative defect then scales as ΔM(N) ≈ N × 3.18 × 10^-38 kg. The mass readout applies to the composite particle, while the erased information is carried by the NV spin states.
Levitated measurement geometry
Section titled “Levitated measurement geometry”The nanosphere is levitated in an optical dipole trap at 1064 nm and a pressure below 10^-8 mbar. The trap measures an effective mechanical frequency rather than rest mass directly. The model writes this frequency as ωm = √(keff/meff(t)), so an isolated mass change shifts the frequency only when trap stiffness remains controlled. The paper denotes the baseline mass as m0 but does not specify its value. The manuscript therefore requires strict bounds on variations in keff against the target shift.
A 1 pJ microwave pulse supplies the expansion scenario considered in the artifact analysis. The proposed event lasts about 1 μs, which makes sub-microsecond timing and phase stability central to the measurement. The optical phase carries the frequency information needed for the mass estimate.
Classical artifact budget
Section titled “Classical artifact budget”The error budget compares the target shift with three classical mechanisms. The table reports order-of-magnitude bounds for a future experiment, not measured suppressions.
| Physical mechanism | Expected frequency shift | Timescale | Relative to target |
|---|---|---|---|
| Target MEIEP signal | ~0.16 μHz | <1 μs | 1.0× |
| Silica thermal expansion | ~0.01 μHz | 100 μs to 1 ms | ~0.1×, spectrally distinct |
| Bulk polarizability shift | ~0.001 μHz | <1 μs | ~0.01×, averages to 0 |
| Microwave photon recoil | ≪0.001 μHz | <1 μs | Negligible |
The expansion estimate uses the Rayleigh limit r ≪ λ. For the dielectric sphere, the paper gives α = 4πε₀R³(ε − 1)/(ε + 2), so keff scales as R³. Classical mass also scales as R³, making the first-order mechanical frequency independent of radius. The residual 0.01 μHz shift is attributed to higher-order optical gradient corrections. The expansion response lasts from 100 μs to 1 ms and is spectrally distinct from the target.
The appendix also bounds bulk polarizability drift. It reports Δk/k < 10^-5 for a fully polarized ensemble. The table lists about 0.001 μHz, while the appendix describes the shift as much smaller than 0.001 μHz. State randomization suppresses the shift toward zero. Microwave photon recoil contributes much less than 0.001 μHz on the sub-microsecond timescale.
Hermetic heat test and interpretation
Section titled “Hermetic heat test and interpretation”In the hermetic seal test, erasure heat remains inside the silica shell. Under the classical account, that heat carries equivalent mass, so total relativistic mass stays constant and ΔM = 0. The proposed signal is an anomalous deficit, ΔM < 0, despite the retained heat.
After the listed artifacts are excluded, the authors interpret this result as evidence for an unaccounted nonthermal mechanical transient. They do not treat it as definitive confirmation of the Mass-Energy-Information Equivalence Principle. Identifying the dissipation channel becomes a separate investigation. A null result with ΔM = 0 would falsify the independent-mass claim at the tested scale. Within the sealed model, it would confine erasure to standard thermodynamic heat transfer.
Signal extraction and timing
Section titled “Signal extraction and timing”The trapping laser’s 1/f phase noise is filtered with a continuous-discrete extended Kalman filter. The filter linearizes the Jacobian of the state evolution f(X(t)) and estimates the time-dependent mass m(t). Its stated purpose is to separate a rapid mass step from transient optical phase shifts. The filter therefore converts phase measurements into an estimate of the effective mass parameter.
Current feedback-cooled sensors have fractional Allan deviations σy² well below 10^-6 for integration times from 1 ms to 10 ms. Because the decoherence event lasts about 1 μs, it falls within this stated stability regime. The filter must therefore preserve sub-microsecond timing while rejecting low-frequency phase drift.
Scaling roadmap and unresolved limits
Section titled “Scaling roadmap and unresolved limits”The central obstacle is the number of entangled spins, not the filtering method. The authors place current diamond-spin entanglement in the thousands and use N ∼ 10^4 as the near-term limit. The scale of N refers to entangled NV spins, not the total defect population. They set the macroscopic target at N ≥ 10^15, which they describe as currently impossible. Reaching it would require cavity-mediated entanglement, phononic waveguides, or strain-engineered diamond lattices.
The proposed Minimal Experiment uses N ∼ 10^8, but the authors expect a null result because its signal falls below the yoctogram noise floor. Such a null result would establish a bound on anomalous mass defects down to about 10^-30 kg. The sequence would first fix a baseline sensitivity limit, then move toward the 10^15 spin regime. No hardware demonstration or NV-network measurement appears in the paper. The reported frequency shifts and artifact suppressions are estimates for a future experiment.
For device engineering, the protocol makes defect density, particle geometry, and silica encapsulation part of the optical and microwave design. The control requirements also include a 1064 nm trap, high vacuum, and sub-microsecond readout. The paper leaves the core dimensions and baseline mass m0 unspecified, so those choices remain part of the hardware design.
Materials and support
Section titled “Materials and support”6CCVD’s diamond materials catalog includes single-crystal and polycrystalline diamond grown by MPCVD, which matches the diamond family used in this levitated optomechanics protocol. The device requires a highly milled nanodiamond core with dense NV centers inside a roughly 250 nm silica nanosphere, plus controlled microwave access and 1064 nm optical trapping. The engineering support page is the appropriate place to resolve the defect and geometry requirements, because the listed products do not establish an off-the-shelf NV nanodiamond product.
View Original Abstract
Theoretical frameworks proposing that quantum information possesses intrinsic physicalmass—such as the Mass-Energy-Information Equivalence Principle (MEIEP)—lack a falsifiable,non-thermal experimental signature at the moment of wave function collapse. Wepropose a rigorous, closed-system optomechanical protocol to bound the existence of nonthermalmechanical transients during controlled macroscopic decoherence. Extending theLandauer limit to highly entangled synthetic systems, we establish parametric scaling boundsfor this mass-equivalent defect: ΔM(N) ≈ N · (3.18×10−38 kg). Utilizing an optically levitatednanodiamond containing a dense network of Nitrogen-Vacancy (NV) centers, we mapa hardware roadmap from current near-term entanglement limits (N ∼ 104) to the macroscopicthreshold (N ≥ 1015), bringing the theoretical signature (ΔM ≥ 3.18 × 10−23 kg)within the yoctogram resolution limit of future feedback-cooled sensors. We provide a quantitativethermodynamic error budget, isolating the informational mass drop from the hermeticseal paradox—where trapped Landauer heat classically enforces ΔM = 0—to probe for ananomalous mass deficit. A Continuous-Discrete Extended Kalman Filter (EKF) pipelineextracts the signal from optical phase noise. This protocol establishes a hardware-readytheoretical probe to bound the mechanical properties of quantum information erasure.
Products
View Specs →
Single Crystal Cvd Diamond Plate
View Specs →