Secondary particle acquisition system for the CERN beam wire scanners upgrade
At a Glance
Section titled āAt a Glanceā| Metadata | Details |
|---|---|
| Publication Date | 2015-04-22 |
| Journal | Journal of Instrumentation |
| Authors | J.L. Sirvent, B. Dehning, Jonathan Emery, Ć. DiĆ©guez |
| Institutions | Universitat de Barcelona, European Organization for Nuclear Research |
| Citations | 3 |
Abstract
Section titled āAbstractāThe increasing requirements of CERN experiments make essential the upgrade of beam instrumentation in general, and high accuracy beam profile monitors in particular. The CERN Beam Instrumentation Group has been working during the last years on the Wire Scanners upgrade. These systems cross a thin wire through a circulating beam, the resulting secondary particles produced from beam/wire interaction are detected to reconstruct the beam profile. For the new secondary shower acquisition system, it is necessary to perform very low noise measurements with high dynamic range coverage. The aim is to design a system without tuneable parameters and compatible for any beam wire scanner location at the CERN complex. Polycrystalline chemical vapour deposition diamond detectors (pCVD) are proposed as new detectors for this application because of their radiation hardness, fast response and linearity over a high dynamic range. For the detector readout, the acquisition electronics must be designed to exploit the detector capabilities and perform bunch by bunch measurements at 40MHz. This paper describes the design challenges of such a system, analysing different acquisition possibilities from the signal integrity point of view. The proposed system architecture is shown in detail and the development status presented.