Skip to content
6CCVD Research

Mechanical Design of Pulse-by-Pulse X-Ray Beam Position Monitor Using Diamond Heat Sink

At a Glance

Section titled ā€œAt a Glanceā€
MetadataDetails
Publication Date2017-01-01
JournalJACOW
AuthorsH. Aoyagi, Sunao Takahashi

Abstract

Section titled ā€œAbstractā€

The pulse-by-pulse X-ray beam monitor equipped with microstripline structure had been developed at SPring-8. This monitor has a potential to function as (1) a pulse intensity monitor, (2) a pulse-by-pulse X-ray beam position monitor (XBPM), and (3) a pulse timing monitor. In insertion device beamlines, however, it cannot be used without further improvement because of heat-resistance problem. Therefore, we examined a pulse-by-pulse XBPM for insertion device beamlines by introducing heat resistance structure, which employed a diamond heat sink. Thermal finite element analysis was carried out to design an effective structure of a detector head and the holder. Evaluation tests of the prototype will be also presented in this contribution.

Tech Support

Section titled ā€œTech Supportā€

Original Source

Section titled ā€œOriginal Sourceā€

Reads Similar to This

Mapping phonon dynamics to thermal transport via deep-learning NEMD - AlN/diamond interface engineering for GaN heat dissipation Nitride Heterostructures and High-Electron-Mobility Transistors on Composite Silicon-Polycrystalline Diamond Substrates Gamma sensitivity of single-crystal CVD diamond neutron detectors