Skip to content

Optical probing of phononic properties of a tin-vacancy color center in diamond

FieldValue
JournalPhysical Review Research
Published2026-04-02
AuthorsCem Güney Torun, J. H. D. Munns, F. Herrmann, Viviana Villafañe, Kai Müller
DOI10.1103/swkr-r6mb
Citations1

Coherent population trapping measured a 31(5) ps orbital relaxation time for a tin-vacancy center at 4 K. The same experiment gave a 958(138) ns orbital excitation time. Temperature-dependent spectroscopy placed the change from single-phonon to two-phonon broadening near 24 K.

Phononic processes and the measurement target

Section titled “Phononic processes and the measurement target”

The negatively charged SnV center has two orbital ground states and two excited states. The C and D optical transitions share the excited state, but their ground states differ by about 820 GHz. Spin-conserving phononic transitions connect the ground states and can limit spin coherence.

Direct time-domain measurements of picosecond rates are difficult because they require synchronized pulses and low-jitter photon detection. The authors therefore combine temperature-dependent linewidth spectroscopy with coherent population trapping. CPT detects the frequency signature of orbital coherence and converts it into its conjugate time variable, giving picosecond resolution.

The rate model ties upward excitation to downward relaxation through γ₊ = γ₋ exp[-ℏω₁₂/(kBT)]. At cryogenic temperature, the upper orbital state relaxes rapidly while excitation into it is slow. Because the orbital transitions preserve spin, the orbital excitation time sets an upper limit on spin coherence when phonons dominate.

Emitter E1 was in a commercial CVD-grown IIa-type (100) electronic-grade single-crystal diamond. Sn ions were implanted at 35 MeV to about 4.35 µm at a nominal fluence of 10⁹ ions/cm². The sample was treated at 7.9 GPa and 2100 °C for about 20 min. A focused-ion-beam hemispherical solid immersion lens had a radius of 4.35 µm.

E1 had a power-broadening and phonon-subtracted linewidth of 37.3(9) MHz. The lifetime-limited linewidth was 32.0(8) MHz, and the measured lifetime was 5.0(2) ns. The authors regard the close match as evidence that one emitter can produce indistinguishable photons.

Emitter E2 came from a second CVD-grown (100) single-crystal diamond. Tin implantation used 400 keV, a fluence of 5 × 10¹⁰ atoms/cm², and an estimated depth of about 100 nm. Vacuum annealing ran at 1050 °C for about 12 hours below 7.5 × 10⁻⁸ mbar. E2 was processed into a 240 nm diameter nanopillar.

Cryogenic measurements used a closed-cycle helium cryostat, with temperature-dependent spectra starting at 4.5 K. For CPT at 4 K, a 619 nm C laser remained resonant while a 619 nm D laser scanned. A 450 nm blue laser reinitialized charge, and avalanche photodiodes collected fluorescence.

At 40 K and below, the authors recorded photoluminescence excitation spectra by repeatedly scanning a resonant laser and counting sideband photons. Above 40 K, they extracted linewidths from nonresonant photoluminescence because the lines exceeded the scan range. They subtracted the 32.0(8) MHz natural linewidth and corrected for power broadening.

Fitting the C transition with the Boltzmann single-phonon model gave its best goodness of fit at 24 K, with R² = 0.98. The extracted coupling coefficients were α₋ = (2π)⁻³ × 7.0(6) × 10⁻⁹ GHz⁻² and α₊ = (2π)⁻³ × 3.8(3) × 10⁻⁹ GHz⁻². Their factor-of-two difference is unexplained, although α₋ agrees with the cited prior value of (2π)⁻³ × 7.51 × 10⁻⁹ GHz⁻².

Two-phonon data were described with cubic scaling. The fitted coefficients were A₊ = 2.52(8) × 10⁻⁴ GHz/K³ and A₋ = 3.8(1) × 10⁻⁴ GHz/K³. The model diverged from measured values between 24 and 40 K. The authors attribute this difference to the transition between single-phonon and two-phonon regimes. They also report the first measurement of D-transition broadening in an SnV center.

The same spectra showed temperature-dependent shifts of both zero-phonon lines. Their extrapolated 0 K wavelengths were 619.058 nm for C and 620.111 nm for D. A diamond thermal-expansion model did not reproduce either trend.

The phonon interaction model gave better agreement. Its quadratic coefficients were A_C = 4.2(7) × 10⁻⁶ nm/K² and A_D = 1.4(6) × 10⁻⁶ nm/K². The quartic coefficients were B_C = 2(6) × 10⁻¹¹ nm/K⁴ and B_D = 0(6) × 10⁻¹¹ nm/K⁴. The authors attribute the dominant quadratic term to E-symmetric phonons below 110 K.

At 4 K, the C laser was held on resonance while the D laser scanned the shared excited state. The fluorescence dip was fit with a Lindblad master equation. Its free parameters were the two Rabi frequencies and the orbital relaxation rate γ₋. The excitation rate γ₊ was fixed by the Boltzmann relation. Pure dephasing γ_d was set to zero because the linewidth data indicated single-phonon dominance below 24 K.

Nine laser-power configurations were scanned in both directions, producing 18 measurements. The authors used 16 because the lowest-power signals were too small. Fits used a ground-state splitting of 831 GHz and a sample temperature of 3.86 K.

The averaged orbital excitation time was 958(138) ns, while orbital relaxation was 31(5) ps. The frequency-to-time transformation resolved the relaxation on a picosecond scale. A 30 ps process is about ten times shorter than the electronic jitter of standard avalanche photodiodes. It also lies at the resolution limit of state-of-the-art superconducting nanowire detectors.

The independent E2 D-transition spectrum supports the CPT rate. At 4 K, the D-transition ground-state population was below 0.1%. Detecting the line required 800 nW, about 8000 times the roughly 100 pW used for C. The measured linewidth was 5.406(43) GHz.

After subtracting lifetime, power-broadening, and spectral-diffusion terms, the analysis gave T₋,D = 30.6(2) ps. This agrees with 31(5) ps from CPT. The correction is an estimate because it assumes that D and C couple equally to external charge noise.

At 4 K, the 31(5) ps upper-branch lifetime makes that orbital branch unsuitable for a practical qubit. The 958(138) ns orbital excitation time provides an upper bound on spin T2* if phonon excitation dominates and the spin bath and gate errors remain minor.

Using the measured α₊ in the Boltzmann model, the authors estimate a 91(8) ms orbital excitation time at 1.8 K. This is about one order of magnitude above the reported 10 ms SnV spin coherence time. They therefore expect phonons not to limit spin coherence at 1.8 K or below. The estimate does not remove other dephasing mechanisms.

The paper contrasts SnV spin coherence around 2 K with SiV results that require millikelvin temperatures. The 1.8 K estimate leaves other dephasing mechanisms as the possible limit.

The fit placed pure orbital dephasing at or below 149(84) ps under a 5% dip-visibility criterion. This is a bound from perturbing the fit, not a direct dephasing measurement. Laser and alignment drift added uncertainty. The C laser power changed by 10% to 50% over three-hour measurements. The dye laser drifted by up to ±40% in 30 minutes. Sample motion reached about 100 nm per hour, and fluorescence fell by about 10% per hour. The fit therefore treated both Rabi frequencies as independent parameters.

For material selection, the linewidth study used an emitter with near-lifetime-limited optical performance. For device engineering, the D transition presents a clear access cost because its population falls below 0.1%. It required 800 nW and charge reinitialization. CPT provides a route to estimate ultrafast orbital decoherence when direct timing is impractical.

The SnV emitters require tin-implanted, annealed, (100)-oriented single-crystal diamond before fabrication of solid immersion lenses or nanopillars. 6CCVD’s diamond materials catalog includes MPCVD-grown single-crystal plates and wafers up to 125 mm, which offer a starting-material family for this implantation route. The linked engineering support can review the orientation, implantation, annealing, and nanostructure specifications.

View Original Abstract

The coherence characteristics of a tin-vacancy (SnV) color center in diamond are investigated through optical means, including linewidth broadening effects and coherent population trapping (CPT) between the ground-state orbital levels. Spectral analysis is required as due to the large spin-orbit splitting of the orbital ground states, thermalization between the ground states occurs at rates that are impractical to measure directly in the time domain. First, by implementing a temperature-dependent linewidth broadening measurement, including the challenging-to-measure D transition, phononic coupling coefficients are determined. These measurements are performed on an emitter with a lifetime-limited linewidth and atomlike properties, making the measurement representative for high-quality SnVs. Next, a CPT-type experiment is carried out to independently analyze thermal decoherence processes at 4 K. The spectral information is transformed into its conjugate variable time, providing picosecond resolution and revealing an orbital depolarization timescale of <a:math xmlns:a=“http://www.w3.org/1998/Math/MathML”> <a:mrow> <a:mo>∼</a:mo> <a:mn>30</a:mn> <a:mrow> <a:mspace width=“0.28em”/> <a:mi>ps</a:mi> </a:mrow> </a:mrow> </a:math> . Consequences of the investigated dynamics are then used to estimate spin dephasing times limited by thermal effects.