Nanodiamond Sensingof the Transmetalation Kineticsof Gd-DTPA in Individual Levitated Microdroplets
Paper details
Section titled “Paper details”| Field | Value |
|---|---|
| Journal | Figshare |
| Published | 2026-06-16 |
| Authors | Emily K. Brown, Zachary R. Jones, Adrisha Sarkar, Brandon J. Wallace, Ashok Ajoy |
| DOI | 10.1021/acs.jpcb.6c01528.s001 |
Nanodiamond ODMR measured Gd³⁺ release from Gd-DTPA in individual levitated microdroplets at fitted rates of 0.00093 s⁻¹ to 0.0029 s⁻¹. The rate rose from 0.00093 s⁻¹ at 0.05 M HCl to 0.0029 s⁻¹ at 0.24 M HCl. Bulk nanodiamond ODMR and proton NMR provided an independent check of the reaction kinetics.
Rates at controlled pH and acid conditions
Section titled “Rates at controlled pH and acid conditions”Each kinetic experiment used 1.5 mM Gd-DTPA and 48 mM zinc acetate in 45% glycerol. Bulk measurements used nominally 140 nm nanodiamonds, while droplet measurements used nominally 100 nm particles. HCl set pH in the pH series and served as the varied additive in a separate HCl series.
The pH series produced the following fitted first-order rate constants.
| Method | pH | kobs (s⁻¹) |
|---|---|---|
| NMR | 6.2 | 0.0018 |
| NMR | 4.7 | 0.0022 |
| NMR | 4.3 | 0.0025 |
| NMR | 3.9 | 0.0088 |
| Bulk ND ODMR | 6.2 | 0.0025 |
| Bulk ND ODMR | 4.7 | 0.0026 |
| Bulk ND ODMR | 4.3 | 0.0042 |
| Bulk ND ODMR | 3.9 | 0.0058 |
The separate HCl series produced another set of fitted rates.
| Measurement | HCl (M) | kobs (s⁻¹) |
|---|---|---|
| Bulk ND ODMR | 0 | 0.004 |
| Bulk ND ODMR | 0.05 | 0.0045 |
| Bulk ND ODMR | 0.07 | 0.0062 |
| Bulk ND ODMR | 0.09 | 0.0072 |
| Droplet ND ODMR | 0.05 | 0.00093 |
| Droplet ND ODMR | 0.14 | 0.00145 |
| Droplet ND ODMR | 0.24 | 0.0029 |
Higher HCl concentration corresponded to a higher fitted rate in both measurement modes. The raw data therefore support a measurable HCl dependence, although they do not isolate its cause.
Nanodiamond ODMR calibration
Section titled “Nanodiamond ODMR calibration”The zinc acetate reaction drove Gd³⁺ release from Gd-DTPA. The authors calibrated bulk ODMR response against total Gd³⁺ concentration with a photophysical model described in prior work. Model inputs included the estimated Gd³⁺ binding-site concentration, gadolinium acetate stability constants, and diamond diameter.
Although DLS gave a nominal diameter of 140 nm, the model used an effective diameter of 56 nm because the particles were aspheric. At approximately 0.85 Gd³⁺ binding sites per nm², the total site concentration was about 1 × 10⁶ M in all bulk measurements. Visual MINTEQ version 3.1 gave gadolinium acetate stability constants for each condition. They were 380 M⁻¹ at pH 6.2, 141 M⁻¹ at pH 4.7, 62 M⁻¹ at pH 4.3, 23 M⁻¹ at pH 3.9, and 2 M⁻¹ at pH 2.7.
The 100 nm and 140 nm samples showed no difference in bulk reaction kinetics at pH 6.2. The authors suggested that broad particle-size distributions likely caused this result.
NMR cross-check and free Gd³⁺ quantification
Section titled “NMR cross-check and free Gd³⁺ quantification”NMR provided a bulk reference for the ODMR kinetics. The authors defined the relaxation rate R as the inverse of the ¹H T1. Concentration-response slopes gave relaxivities of 9.1 ± 0.3 s⁻¹ mM⁻¹ for Gd-DTPA and 0.0006 ± 0.0001 s⁻¹ mM⁻¹ for zinc acetate. GdCl₃ gave 41 ± 2 s⁻¹ mM⁻¹, while gadolinium acetate gave 24 ± 1 s⁻¹ mM⁻¹. The 45% glycerol background was 0.91 ± 0.04 s⁻¹.
Kinetic R values were recorded at approximately 1 minute intervals. Each kinetic data set averaged at least three independent measurements. The observed R equation combined Gd-DTPA, free Gd³⁺, and zinc acetate contributions.
Free-Gd³⁺ relaxivity changed with pH because acetate protonation altered gadolinium coordination. GdCl₃ had a relaxivity of 41 s⁻¹ mM⁻¹ without acetate, but only 24 s⁻¹ mM⁻¹ with acetate at pH 6.6. At pH 6.6, about 98.7% of free Gd³⁺ was coordinated with at least one acetate. At pH 4, about 87.4% was acetate-coordinated.
The selected free-Gd³⁺ relaxivities were 28, 30, 32, and 35 s⁻¹ mM⁻¹ at pH 6.2, 4.7, 4.3, and 3.9. The corresponding equilibrium free-Gd³⁺ concentrations were 1.45, 1.42, 1.39, and 1.33 mM. The authors selected these values to agree with literature stability constants from MINTEQ or Jászberényi et al. The free-Gd³⁺ relaxivity affected the equilibrium concentration but not the measured rate constant. The NMR quantification followed the method reported by Werner et al. in 2021.
Acetate evaporation inside droplets
Section titled “Acetate evaporation inside droplets”The Kinetiscope model represented the droplet as a rectangular prism with two well-mixed compartments. The 1 nm surface compartment sat above a larger bulk compartment. Its height was set to one-third of the radius to preserve spherical surface-to-volume scaling. The assumed droplet radius was 18 µm.
Acetic acid moved between the compartments according to Fick’s law. The model used a 6 × 10⁸ nm² s⁻¹ diffusion coefficient, a 100 s⁻¹ solvation rate, and a 280 M⁻¹ s⁻¹ desolvation rate. Desorption had a rate of 95 s⁻¹. The maximum surface concentration was 2.6 × 10¹⁴ molecules cm⁻², and the acetic acid partitioning constant was 2.8 M⁻¹.
The maximum surface concentration was assumed to equal that of pyruvic acid. The partitioning constant came from aqueous surface-tension data because no measurements were available for a glycerol and water system. These assumptions limit how closely the model represents the experimental droplet.
The model ran at fixed pH while calculating evaporation as a function of pH. At pH 6, acetate reached one-tenth of its original concentration after about 7.5 minutes. At pH 7, the same reduction took about 71 minutes.
The authors expected the reaction pH to plateau near pH 6 to 7 when acetate exceeded HCl. When HCl exceeded acetate, they expected complete acetate evaporation as acetic acid. These are model-based expectations rather than direct pH measurements during each droplet reaction.
Agreement between ODMR and NMR
Section titled “Agreement between ODMR and NMR”At pH 6.2, bulk ND ODMR gave 0.0025 s⁻¹, compared with 0.0018 s⁻¹ by NMR. At pH 4.7, the corresponding values were 0.0026 s⁻¹ and 0.0022 s⁻¹. The methods agreed closely at these two conditions.
The methods diverged at lower pH. At pH 4.3, ND gave 0.0042 s⁻¹ against 0.0025 s⁻¹ by NMR. At pH 3.9, ND gave 0.0058 s⁻¹, while NMR gave 0.0088 s⁻¹. The measurements therefore agreed on the rate scale but not on identical values.
The HCl series also showed a bulk-to-droplet difference. At 0.05 M HCl, the bulk rate was 0.0045 s⁻¹, compared with 0.00093 s⁻¹ in droplets. The separate evaporation model does not establish evaporation as the sole cause of this difference.
Limits and unresolved questions
Section titled “Limits and unresolved questions”The supplementary rate tables list fitted values without reported uncertainties. Raw droplet ODMR at 0 M HCl fluctuated around zero, and no fitted droplet rate was reported for that condition. With HCl present, the net response increased over time, but individual measurements remained variable.
The supplied information does not provide a droplet-specific conversion from ODMR response to free-Gd³⁺ concentration. The bulk calibration used a 140 nm nominal particle and a 56 nm effective diameter. Droplet responses therefore support kinetic tracking more directly than absolute concentration measurement.
Figure S2 compares NMR measurements with and without 140 nm ND. The supplied rate tables do not quantify the effect of ND on the NMR result. The evaporation model also depends on an assumed 18 µm radius, a rectangular-prism geometry, and surface parameters borrowed from a different organic acid.
Implications for sensor operation
Section titled “Implications for sensor operation”The measurements support nanodiamond ODMR as a kinetic probe for Gd-DTPA transmetalation in individual microdroplets. For assay design, HCl concentration and pH are direct control variables for the observed rate. Acetate evaporation must also be considered because its modeled timescale overlaps the reaction at pH 6.
Calibration should account for pH-dependent free-Gd³⁺ relaxivity and acetate loss. Particle-size selection based on this experiment alone is not supported, because the tested 100 nm and 140 nm particles showed no difference in bulk kinetics. For droplet ODMR assays, pH control and acetate-loss correction are the more defensible design priorities.
View Original Abstract
Directly measuring kinetics within microcompartments is critical for determining the distinct mechanisms that govern chemistry in confined environments. Here, we deploy nanodiamond (ND) particles hosting nitrogen-vacancy (NV) centers as quantum sensors to track the transmetalation of gadolinium diethylenetriaminepentaacetic acid (Gd-DTPA) in bulk solution and within single levitated, charged microdroplets by optically detected magnetic resonance (ODMR). The appearance of paramagnetic Gd<sup>+</sup>during the reaction produces changes in the continuously acquired ODMR signature, furnishing an in situ optical measurement of kinetics in microscale volumes that are otherwise difficult to interrogate directly. While quantification of [Gd<sup>+</sup>] remains challenging due to the high sensitivity of ODMR to pH and ligand concentration, we find that NDs accurately report on observed rate constants for the reaction over a broad pH range by comparison with NMR measurements. A direct comparison between droplet and bulk ND measurements also allows for a reliable kinetic comparison between the two environments. The transmetalation rate in droplets, with an average radius of 18.6 μm, proceeds significantly slower than in a bulk solution, with up to a 4-fold reduction in the observed rate constant. Additionally, in the absence of added acid, the transmetalation reaction proceeds efficiently in bulk, yet is completely suppressed in droplets, suggesting that microconfinement can modulate reactivity. These findings highlight both the strengths and limitations of ND-based ODMR sensing for probing reaction kinetics in microscale environments.
Electronic Grade Intrinsic Diamond Epitaxial Wafer H Terminated Superior 100 Mosfet Ready Substrate
View Specs →
Free Standing Polycrystalline Cvd Diamond Membrane
View Specs →