Skip to content
6CCVD Research

Analysis error of machining radial Fresnel lens on roller mold

At a Glance

Section titled ā€œAt a Glanceā€
MetadataDetails
Publication Date2019-01-24
AuthorsSujuan Wang, Yawen Guo, Ziqiang Yin
InstitutionsGuangdong University of Technology
Citations1

Abstract

Section titled ā€œAbstractā€

Roll-to-Roll imprint process is considered to be the most promising technology for manufacturing large-area micro-structured surface. However, the traditional turning technique was considered to be incapable of machining radial Fresnel lenses on roller mold. This study deals with the problem of machining the radial Fresnel lens on a roller mold, which is achieved by using the diamond cutting tools mounted on a multiple axis control ultra-precision machining center. In addition, this study simulates the effect of the deviation of the tool tip position from the rotation center of the platform and the deviation from the vertical plane of the roller axis on the machining results.

Tech Support

Section titled ā€œTech Supportā€

Original Source

Section titled ā€œOriginal Sourceā€

References

Section titled ā€œReferencesā€
  1. 2011 - Improvement of machining quality of copper-plated roll mold by controlling temperature variation

Reads Similar to This

Research on suppressing brittle fracture and implementing ductile mode cutting for improving surface quality at silicon wafers manufacturing Surface defects incorporated diamond machining of silicon A Comparison of Residual Stress Induced by Fixed Abrasive Diamond Wire Sawing and Loose Abrasive Slurry Wire Sawing in Multicrystalline Silicon Wafers