Skip to content

Direct optical excitation of an NV center via a nanofiber Bragg-cavity - a theoretical simulation

MetadataDetails
Publication Date2019-09-11
JournalOptics Express
AuthorsToshiyuki Tashima, Hideaki Takashima, Shigeki Takeuchi
InstitutionsKyoto University
Citations9
AnalysisFull AI Review Included
  • Core Innovation: Introduction of a Nanofiber Bragg Cavity (NFBC) to enhance optical excitation of Nitrogen-Vacancy (NV) centers in nanodiamonds, achieving an electric field of 2.6 MV/m at the nanodiamond center.
  • Efficiency Breakthrough: The NFBC design reduces required excitation optical power by approximately 3/100× (from 1 mW down to 31 µW) compared to standard objective lens coupling.
  • Performance Comparison (E-field at nanodiamond center):
    • Objective Lens (NA 0.955): ~0.46 MV/m
    • Nanofiber alone: ~1.1 MV/m
    • Nanofiber Bragg Cavity (NFBC, 80 gratings/side): 2.6 MV/m
  • Spectral Compatibility: NFBC resonant peak at 532 nm with transmission > 0.8 across the 600-700 nm NV fluorescence band, ensuring minimal signal loss.
  • Background Suppression: Cavity-enhanced excitation reduces background photon generation typically induced by light propagating through the nanofiber taper.
  • Application Scope: Quantum photonics, single-photon sources, fiber-integrated quantum magnetometry, and hybrid quantum nanophotonic devices.
  • Methodology: FDTD-based electromagnetic simulation (Lumerical) optimizing grating number, nanofiber taper geometry (237 nm tip), and cavity Q-factor.

ParameterValueUnitContext
Objective Lens NA0.955—Reference focusing element
Nanofiber Tip Diameter237nmSingle-mode tapered fiber region
NFBC Total Length592.5nmCavity physical extent
NFBC Tip Diameter~300nmTapered fiber region integrated with cavity
NFBC Grating Count (Sim 1)80gratings/sideElectric field enhancement configuration
NFBC Grating Count (Sim 2)120gratings/sideTransmission spectrum configuration
E-field via Objective Lens~0.46MV/mBaseline excitation at nanodiamond center
E-field via Nanofiber~1.1MV/mNanofiber-only coupling
E-field via NFBC (80 gratings)2.6MV/m5.7× improvement over objective lens
Cavity Resonant Wavelength532nmDesigned resonance peak
Transmission at NV Fluorescence (600-700 nm)> 0.8—Maintained fluorescence collection efficiency
Required Optical Power (NFBC)31µWEquivalent excitation field as 1 mW objective lens
Power Reduction Factor~0.03 (≈3/100)—Excitation efficiency gain
Nanofiber Laser Power Ratio0.15—Relative to objective lens power for matched field
Grating-Period Optimization Range25-75nmSimulated for transmission tuning

  • Simulation Platform: Finite-Difference Time-Domain (FDTD) electromagnetic solver (Lumerical).
  • Step 1 — Baseline Modeling: Simulated electric field distribution around a nanodiamond coupled to a high-NA objective lens (NA = 0.955) at 532 nm excitation.
  • Step 2 — Nanofiber Coupling: Replaced objective lens with a tapered optical nanofiber (tip Ø ≈ 237 nm) to evaluate evanescent coupling efficiency.
  • Step 3 — NFBC Fabrication Design: Introduced periodic Bragg gratings (grating number varied 0-120 per side) on both sides of the nanofiber to form a resonant cavity.
  • Step 4 — Grating Optimization: Swept grating period (25, 50, 75 nm) and count to map E-field enhancement and transmission trade-offs.
  • Step 5 — Transmission Verification: Calculated transmission spectrum (500-700 nm) for the optimized NFBC (120 gratings/side) to validate fluorescence compatibility.
  • Step 6 — Performance Benchmarking: Compared E-field strength and required excitation power across objective, nanofiber, and NFBC configurations.
  • Step 7 — Background Analysis: Confirmed reduced background photon generation due to lower intracavity pump power requirements.

  • Applicable Materials:

    • Optical-Grade Single Crystal Diamond (SCD): Ideal for NV-center studies; available in controlled defect densities with sub-nm surface roughness (Ra < 1 nm).
    • Polycrystalline Diamond (PCD) Nanoparticles / Micro-Particles: Suitable when cost-scalable nanodiamond feedstocks are required for hybrid photonic integration.
    • Custom NV / SiV Engineering: Tailored nitrogen or silicon incorporation profiles available for emitter yield optimization.
  • Customization Potential:

    • Diamond Geometry: Nanodiamonds down to sub-100 nm dimensions; freestanding SCD membranes from 0.1 µm to 500 µm; PCD plates up to Ø 125 mm.
    • Laser Cutting & Dicing: Precision shaping of diamond substrates into nanowires, micro-pillars, or tapered geometries required for tapered-fiber or cavity-coupled emitter architectures.
    • Surface Engineering: Sub-nm polishing on SCD and < 5 nm Ra on inch-scale PCD — critical for minimizing optical scattering losses at fiber-diamond interfaces.
    • Metallization: Ti / Pt / Au, W, or custom stack metallization available for hybrid integration with photonic crystal fibers or waveguide platforms.
  • Engineering Support:

    • In-house PhD engineering team available to assist with material selection, defect concentration tuning, and geometry optimization for fiber-integrated quantum photonic, magnetometry, and single-photon source projects.
    • Simulation-to-fabrication translation support: from refractive index, NV density, and crystal orientation selection to final dicing and packaging.
  • Call to Action: For custom specifications or material consultation, visit 6ccvd.com or contact our engineering team directly.

View Original Abstract

Direct optical excitation of a nitrogen-vacancy (NV) center in nanodiamond by light via a nanofiber is of interest for all-fiber-integrated quantum applications. However, the background light induced by the excitation light via the nanofiber is problematic as it has the same optical wavelength as the emission light from the NV center. In this paper, we propose using a nanofiber Bragg cavity to address this problem. We numerically simulate and estimate the electric field of a nanodiamond induced by excitation light applied from an objective lens on a confocal microscope system, a nanofiber, and nanofiber Bragg-cavities (NFBCs). We estimate that by using a nanofiber, the optical excitation intensity can be decreased by roughly a factor of 10 compared to using an objective lens, while for an NFBC with a grating number of 240 (120 for one side) on a nanofiber the optical excitation intensity can be significantly decreased by roughly a factor of 100. This reduction of optical excitation intensity will make it possible to distinguish the fluorescence of the NV center from the background light.