Study on the Electro-Fenton Chemomechanical Removal Behavior in Single-Crystal GaN Pin–Disk Friction Wear Experiments
At a Glance
Section titled “At a Glance”| Metadata | Details |
|---|---|
| Publication Date | 2025-02-12 |
| Journal | Micromachines |
| Authors | Yangting Ou, Zhuoshan Shen, Jian‐Jun Xie, Jisheng Pan |
| Institutions | Guangdong University of Technology |
Abstract
Section titled “Abstract”Electro-Fenton chemical mechanical polishing primarily regulates the generation of hydroxyl radicals (·OH) via the Fenton reaction through an applied electric field, which subsequently influences the formation and removal of the oxide layer on the workpiece surface, thereby impacting the overall polishing quality and rate. This study employs Pin-Disk friction and wear experiments to investigate the material removal behavior of single-crystal GaN during electro-Fenton chemical mechanical polishing. Utilizing a range of analytical techniques, including coefficient of friction (COF) curves, surface morphology assessments, cross-sectional analysis, and power spectral density (PSD) measurements on the workpiece surface, we examine the influence of abrasives, polishing pads, polishing pressure, and other parameters on the electro-Fenton chemical-mechanical material removal process. Furthermore, this research provides preliminary insights into the synergistic removal mechanisms associated with the electro-Fenton chemical-mechanical action in single-crystal GaN. The experimental results indicate that optimal mechanical removal occurs when using a W0.5 diamond at a concentration of 1.5 wt% combined with a urethane pad (SH-Q13K-600) under a pressure of 0.2242 MPa.
Tech Support
Section titled “Tech Support”Original Source
Section titled “Original Source”References
Section titled “References”- 2012 - Structural and chemical characteristics of atomically smooth GaN surfaces prepared by abrasive-free polishing with Pt catalyst [Crossref]
- 2003 - Fabrication of GaN wafers for electronic and optoelectronic devices [Crossref]
- 2015 - GaN-based LED micro-displays for wearable applications [Crossref]
- 2020 - Review—Progress in High Performance III-Nitride Micro-Light-Emitting Diodes [Crossref]
- 2013 - 360 PPI Flip-Chip Mounted Active Matrix Addressable Light Emitting Diode on Silicon (LEDoS) Micro-Displays [Crossref]
- 2017 - Inorganic light-emitting diode displays using micro-transfer printing [Crossref]
- 2021 - 4.343-Gbit/s Green Semipolar (20-21) μ-LED for High Speed Visible Light Communication
- 2021 - Ultrafast 2 × 2 green micro-LED array for optical wireless communication beyond 5 Gbit/s [Crossref]
- 2012 - Atomically Smooth Gallium Nitride Surfaces Prepared by Chemical Etching with Platinum Catalyst in Water [Crossref]