Skip to content

Quantum sensors for enhanced positioning and navigation - a comprehensive review

FieldValue
JournalGPS Solutions
Published2026-02-01
AuthorsHaobo Li, Safoora Zaminpardaz, Allison Kealy, Andrew D. Greentree, Eldar Rubinov
DOI10.1007/s10291-026-02030-y
Citations3

A cited field trial reported up to a 46-fold reduction in positioning error against a strategic-grade inertial system in airborne and ground-based trials. The review presents this as evidence for resilient, layered positioning, navigation, and timing, not as grounds for replacing GNSS.

The review identifies absolute measurement, long-term stability, and reduced dependence on external signals as the main quantum advantages for PNT. Cold atom interferometry, atomic vapor cells, SQUIDs, and solid-state defect sensors cover different operating conditions and navigation tasks. The review treats quantum clocks only briefly because it deliberately excludes timing from its main analysis. Most systems remain at laboratory or early prototype maturity, so the best laboratory sensitivity is not a field-readiness result. The authors conclude that quantum sensors should complement classical systems inside multi-sensor PNT architectures. None of the reviewed modalities is presented as a universal replacement for GNSS.

The authors used a literature review of standalone and hybrid quantum-classical architectures. No datasets were generated or analyzed, so the review’s numerical results come from cited experiments and simulations. The synthesis compares sensor performance with GNSS, inertial navigation, LEO PNT, natural-field map matching, and ambient radio signals. GNSS signals are typically around -130 dBm, which leaves them vulnerable to jamming and spoofing. A 1 W interferer operating in GNSS bands can disrupt reception over several kilometres. Blockage and multipath degrade or remove signals in urban canyons, dense forests, underground, and underwater settings. LEO signals at 780 km were reported about 30 dB stronger than GPS signals, but large constellations and replenishment remain necessary. Inertial navigation avoids external signals, yet bias and drift accumulate without aiding. A navigation-grade accelerometer with approximately 10 microg stability can induce about 60 m horizontal error over the 84.4-minute Schuler period without GNSS aiding.

Cold atom accelerometers and gyroscopes interfere laser-cooled atomic waves, converting inertial phase shifts into motion estimates. Magneto-optical traps typically operate in the tens of microkelvin regime, while Bose-Einstein condensates reach nanokelvin temperatures. Raman gravimetry is independent of atomic mass and isotopic composition, although mixed isotopes create incoherent interferometer paths and reduce contrast. Atomic vapor cells use rubidium or caesium at room or elevated temperatures, with Doppler-free probing narrowing the response linewidth. SERF magnetometers operate at high atomic density under low magnetic fields and monitor atomic spin changes with laser light. SQUIDs detect magnetic fields through phase-coherent supercurrents in superconducting loops, but they require cryogenic conditions. NV centres form when nitrogen substitutes for carbon beside a vacancy in the diamond lattice. Optical excitation and readout let NV sensors measure all three magnetic-field components at room temperature. NV sensors also operate reliably from cryogenic temperatures up to 600 to 700 K. Squeezed or entangled light can improve interferometric phase estimation, although quantum positioning systems remain at laboratory feasibility stage.

Measured performance under stated conditions

Section titled “Measured performance under stated conditions”

The reported results depend on platform, bandwidth, and environmental control.

TechniqueOperating conditionReported resultNavigation relevance
Cold atom accelerometerThree-axis mobile accelerometerPer-shot sensitivity: X 10.8 µg, Y 5.5 µg, Z 4.4 µgIndicative 60 s drifts: 0.19 m, 0.10 m, 0.08 m
Cold atom gravimeterMobile laboratory and field operation37 µGal/√Hz; stability better than 2 µGal over 30 minField uncertainty below 40 µGal; position still needs gravity maps
Bulk NV magnetometerBroadband dc mode without a flux concentrator460 fT/√HzLow-strain diamond, double-quantum protocol, waveguide and balanced detection
Portable NV vector magnetometerRoom temperature, unshielded vehicle trial0.3 nT/√HzVector measurement requires platform correction and magnetic maps
Hybrid accelerometerMatter-wave and classical accelerometers10⁻⁷ m/s² after 11 h; Schuler oscillations within 60 mmBounds accelerometer drift with classical assistance

The bulk NV result uses low-strain diamond growth, double-quantum magnetometry, a light-trapping waveguide, and balanced photodetection. A compact room-temperature NV magnetometer reached about 7 nT/√Hz across 125 Hz in unshielded conditions. The review’s comparison table lists optically pumped magnetometers at 20 fT/√Hz and SQUIDs at 30 to 80 fT/√Hz. These figures come from different operating modes and platforms, so the table does not establish a universal ranking. The mobile gravimeter measured gravity directly, while position still required a gravity map and matching algorithm. Indicated position drifts from the mobile accelerometer assume constant single-axis bias, so they are not complete IMU error predictions.

Why hybrid systems are the practical route

Section titled “Why hybrid systems are the practical route”

Classical MEMS accelerometers and gyroscopes sample at kilohertz rates, while quantum inertial sensors offer better long-term accuracy with lower bandwidth. Hybrid INS uses fast classical measurements to anchor or unwrap quantum phase, then fuses both streams into a stable navigation solution. This reduces the need for repeated GNSS or beacon calibration during long autonomous missions. In a 1000-run simulation, phase fusion cut specific-force RMS error by one order of magnitude and velocity RMS error by about 50%. The same study moved position error from several metres to sub-metre levels. Adding partial quantum gravity-gradient data reduced flight-path error from 4 km with classical INS to 300 to 400 m. A gravity map-matching simulation reduced position error accumulation by 6% over 3.5 hours against standalone precision-grade sensors. A magnetic-aided simulation produced 250 to 500 m position errors for a vehicle at 22 m/s and 100 m altitude over 3.6 hours. These results came from separate studies, not one integrated navigation system. The review therefore treats hybrid fusion as the most likely deployment path while withholding claims of general field readiness.

Deployment constraints and selection criteria

Section titled “Deployment constraints and selection criteria”

The authors identify decoherence, thermal noise, electromagnetic disturbance, vibration, phase wrapping, and calibration error as barriers. Cold atoms need vacuum and precise lasers, while SQUIDs need cryogenic cooling. Atom interferometers also incur dead time, limited bandwidth, restricted dynamic range, and high size, weight, power, and cost. Most quantum magnetometers remain two to three orders of magnitude above their fundamental sensitivity floors. Vector magnetic navigation lacks widely available anomaly maps, and scalar maps cannot fully reconstruct changing platform attitudes. Moving metal creates platform-dependent magnetic signatures that must be removed with a compensation model. Gravity-aided navigation also requires local gravity subtraction, so accurate three-dimensional maps may set the final error limit. Most quantum sensors use single units or ensembles, and few demonstrate a clear quantum advantage under field conditions. Engineering comparisons should include sensitivity, bandwidth, dynamic range, bias drift, scale-factor stability, update rate, and heading error. Navigation evaluations should add GNSS holdover, map resolution, map fidelity, platform alignment, and correction-model error. Gyroscope error and platform alignment often dominate the mid-term and long-term inertial error budget. The authors call for field robustness, miniaturization, integration, and metrics that quantify quantum performance. Engineers should select a sensor set for the navigation task rather than assume one quantum modality fits every case. Hybrid systems are best viewed as complements to GNSS and classical inertial sensors during the current development stage.

The review’s NV-centre magnetometer requires diamond with engineered NV point defects, optical excitation, and readout. 6CCVD’s diamond materials catalog lists MPCVD-grown single-crystal and polycrystalline plates and wafers, 0.1 to 500 micrometers thick, without stating NV defect performance. Device-specific metallization and polishing requirements can be discussed through the engineering support page.

View Original Abstract

Abstract The inherent vulnerability of Global Navigation Satellite Systems (GNSS) to interference, spoofing, and signal degradation highlights the urgent need for robust augmentation and alternative solutions to support resilient Positioning, Navigation, and Timing (PNT) services. Among emerging technologies, quantum sensing stands out for its ability to harness fundamental quantum phenomena, such as superposition and entanglement, enabling absolute, drift-free and ultra-sensitive measurements of inertial forces, gravity, and magnetic fields with long-term stability and reduced dependency on external signals. This capability offers a promising pathway to enhance positioning and navigation performance in GNSS-denied or GNSS-contested environments. Here, we present a comprehensive review of quantum sensing technologies in the context of positioning and navigation, including cold atom interferometry, atomic vapour cell, superconducting quantum interference devices, and room temperature solid-state systems like nitrogen-vacancy centres in diamond, and their potential to support positioning and navigation across a range of operational contexts. Both standalone and hybrid quantum-classical architectures are examined, with case studies illustrating their ability to reduce navigation drift and achieve sub-metre accuracy through quantum-enhanced inertial navigation, gravity-aided positioning, and magnetic field-matching approach. Despite their promise, challenges including decoherence, environmental robustness, miniaturisation, and integration complexity remain significant barriers to practical deployment. Rather than replacing existing classical systems, quantum sensors are best served as complementary solutions within multi-layered PNT frameworks. This review also identifies priorities for advancing field-deployable quantum positioning and navigation solutions, including sensor robustness, miniaturisation, seamless integration, and the development of protocols to quantify quantum performance. Aligned with international quantum initiatives, this work contributes to the vision of secure, interference-resistant navigation infrastructure for scientific, industrial, and defence applications.