Skip to content

Quantum Impurity Sensing of Altermagnetic Order

FieldValue
JournalPhysical Review Letters
Published2026-03-11
AuthorsVictor A. S. V. Bittencourt, Hossein Hosseinabadi, Jairo Sinova, Libor Šmejkal, Jamir Marino
DOI10.1103/2ppn-kvjv

A modeled nitrogen-vacancy relaxometry protocol distinguishes an altermagnetic insulator from a conventional antiferromagnet. The calculated contrast reaches 8/12 ≈ 0.67 when D2 is close to D1, a 27% increase over 11/21 ≈ 0.52 at large separation. The work is a theoretical sensing proposal, not an experimental measurement.

A distance-dependent altermagnetic fingerprint

Section titled “A distance-dependent altermagnetic fingerprint”

Altermagnets have no net magnetization, but their spin-split bands break time reversal. They differ from antiferromagnets through anisotropic spin polarization and momentum-space nodes. The d, g, and i forms meet at two, four, or six spin-degenerate nodes.

The proposed method reads these differences through magnetic noise at a nearby spin impurity. Altermagnetic order changes the orientation dependence of the impurity relaxation rate as the sample-to-impurity distance changes. Conventional magnets produce a flat contrast under the same analysis.

That distance dependence is the altermagnetic fingerprint. Antiferromagnets and ferromagnets retain a distance-independent contrast in the proposed comparison. A single relaxation-rate measurement therefore offers less discrimination than a distance-dependent orientation scan.

How NV relaxometry measures the magnetic field

Section titled “How NV relaxometry measures the magnetic field”

NV centers provide a local, noninvasive readout through T1 relaxometry. Their magnetic moment couples through dipolar interaction to noisy stray fields from magnetic excitations. Those fields add an extrinsic contribution to the intrinsic T1 relaxation rate.

Transverse correlations can drive single-magnon processes when the impurity frequency matches the magnon frequency. Altermagnetic magnon gaps are typically around THz, while the NV transition is around GHz. Longitudinal correlations therefore dominate under the paper’s weak-field, easy-axis conditions. They correspond to two-magnon processes and carry the spin-transport information.

Measuring T1 isolates this extra decay after accounting for phonon, magnetic, electric, and strain contributions. Because the rate depends on longitudinal and transverse correlations, the frequency and field conditions form part of the protocol.

The dipolar geometric factor contains k² exp(-2kd). It suppresses very small and very large wavevectors, so the integral selects k near 1/d. This distance sets the momentum window interrogated by the measurement.

Rotating the NV axis changes the geometric weighting of the same modes. Two defects with different axes can provide the orientation set without moving the sample.

Diffusion response in the altermagnetic model

Section titled “Diffusion response in the altermagnetic model”

The authors model a two-dimensional d-wave altermagnet on the Lieb lattice. The Heisenberg Hamiltonian uses nearest-neighbor exchange J1, directional next-nearest exchange J2 ± Δ, and easy-axis anisotropy JEA. The model assumes an in-plane Néel state supported by that anisotropy.

First-order Holstein-Primakoff diagonalization produces two alternating magnon bands. The band gap keeps single-magnon transitions off resonance with the GHz impurity transition. For J1 ≈ 10 meV, even weak anisotropy can satisfy this frequency separation.

The calculated longitudinal response contains a directional term proportional to k⁴ cos²(2φk). That term distinguishes altermagnetic diffusion from the isotropic response of conventional magnets. The calculated magnon bands also retain fourfold rotation symmetry in momentum space.

The diffusion tensor has diagonal components D1 and opposite off-diagonal components D2. At Δ = 0, D2 vanishes and the model reduces to a Lieb lattice antiferromagnet. The nonvanishing off-diagonal component is therefore the model-specific altermagnetic signature. The authors expect these tensor relations to apply to any d-wave altermagnet.

The contrast summarizes the maximum and minimum relaxation rates over relative NV and Néel orientations. The maximum occurs at θ = π/2 and φ = 0. The minimum occurs at θ = π/2 and φ = π/2.

For d much greater than l0, the contrast equals 11/21 ≈ 0.52. Here l0 = √(D1τs) is the isotropic spin diffusion length. At this distance, altermagnetic anisotropy is washed out, so an antiferromagnet gives the same value.

For d much less than l0, the contrast reaches 8/12 ≈ 0.67 when D2 is close to D1. This is a 27% increase over 11/21. The relaxation rate retains the same d⁻² scaling for both magnetic classes. Only the orientation contrast exposes the difference at short range.

Earlier noise-spectroscopy models explain orientation anisotropy through the Néel vector. Altermagnetic band splitting adds a contribution that changes with distance.

The contrast also depends on D2/D1, d/l0, and ωτs. These dependencies allow the distance scan to extract intrinsic diffusion parameters. Figure 3 uses J2 = -0.8J1, JEA = 0.01J1, and ωτs = 1. It reports about 17% growth between d ≈ l0 and d ≪ l0. The increase therefore depends on the selected parameters.

All curves were produced by numerical integration of the full relaxation-rate expression.

Numerical benchmarks and measurement requirements

Section titled “Numerical benchmarks and measurement requirements”

The feasibility calculation uses τs ≈ 10 ns, J1 = 10 meV, lattice constant a ≈ 3 Å, and magnon momentum relaxation time τ ≈ 10 ps. It gives l0 ≈ 2.0 μm.

Commercial all-diamond probes can place an NV approximately 50 nm from the sample. That range reaches the d ≪ l0 regime needed to resolve the anisotropic contribution. The characteristic rate Γc is about 25 Hz for the representative parameters. This is comparable to the intrinsic relaxation rate at 200 K.

CaseParametersContrastRate requirement
Representative benchmarkd ≈ 1.6 μm0.53Distinguish 102 Hz from 31 Hz
Maximum anisotropyD2 ≈ D1, d < 0.1l08/12 ≈ 0.67Rates of a few hundred kHz

Measurements of the close-range rates require operation below 200 K. Low temperature and high-quality diamond can reduce phonon and magnetic contributions to intrinsic relaxation. Electric and strain noise depend mainly on the NV depth below the diamond surface. Fabrication can optimize that depth, according to the paper.

Typical measured T1 errors are below 10%, which supports moderate D2/D1 ratios. Two axes separated by π/3 lower the contrast to about 0.8 of its ideal value. Rotating the diamond while holding the sample fixed is an alternative orientation control.

Optical readout remains technically limited, but it is an established method. State-of-the-art systems can measure the required close-range rates.

The results remain model calculations within the stated assumptions. They treat a two-dimensional Lieb lattice, a high-temperature Bose distribution, and momentum-independent magnon relaxation. At low temperature, magnon-magnon scattering can become relevant and is omitted.

The zero-frequency limit is used for analytic expressions, while plotted results retain finite ω = 1/τs. The apparent singularity at D2 = D1 is an artifact of that zero-frequency approximation.

The spin conductivity estimate of 3.8 × 10⁶ S/m at 200 K is described as rough. A fuller treatment of ballistic spin transport is left for future work. Reported estimates address measurement feasibility rather than a demonstrated material measurement.

Metallic altermagnets require extra analysis of Johnson noise, mobile moments, spin-momentum locking, and nodal electronic structure. T2 relaxometry may suit their gapless modes because its signal is stronger and its frequency range is lower.

Multi-qubit NV noise spectroscopy could resolve spatial correlations and correlation spreading. This supports spin-transport studies without modifying the altermagnetic sample.

The sensing element requires a high-quality diamond host containing an NV spin defect near a two-dimensional altermagnetic sample. The 6CCVD diamond materials catalog lists MPCVD-grown single-crystal and polycrystalline diamond plates and wafers up to 125 mm. The paper also requires controlled defect depth and axis, so use the engineering support page for custom fabrication support.

View Original Abstract

Quantum sensing with individual spin defects has emerged as a versatile platform to probe microscopic properties of condensed matter systems. Here we demonstrate that quantum relaxometry with nitrogen-vacancy (NV) centers in diamond can reveal the anisotropic spin dynamics of altermagnetic insulators together with their characteristic spin polarised bands. We show that the distance and orientation dependent relaxation rate of a nearby quantum impurity encodes signatures of momentum space anisotropy in the spin diffusion response, a hallmark of altermagnetic order. This directional sensitivity is unprecedented in the landscape of quantum materials sensing, and it enables the distinction of altermagnets from conventional antiferromagnets via local, noninvasive measurements. Our results could spark new NV-sensing experiments on spin transport and symmetry breaking in altermagnets, and highlight the role of NV orientation to probe anisotropic phenomena in condensed matter systems.