Comparison of the Effect of Adhesive Protocols and Light Curing Units on the Repair Bond Strength of Bulk Fill Composite Resins
At a Glance
Section titled āAt a Glanceā| Metadata | Details |
|---|---|
| Publication Date | 2024-11-15 |
| Journal | Selcuk Dental Journal |
| Authors | KĆ¼bra Bilge, Ä°rem Ä°pek, Enes Mustafa AÅAR |
| Institutions | Fırat University, SelƧuk University |
Abstract
Section titled āAbstractāBackground: The aim of this study is to compare the shear bond strength (SBS) after the repair of a microhybrid composite resin (CR) with three different bulk fill CRs using a 2nd and 3rd generation light-emitting diode (LED) light curing units and a universal adhesive with different application protocols. Methods: 120 acrylic blocks, each with an open surface and a depth of 2 mm and a diameter of 6 mm, were filled with a microhybrid CR (Filtek Z250) and cured with an LED for 20 seconds. The samples were roughened for 5 seconds with a diamond fissure bur under water cooling and then subjected to 5,000 thermal cycles. A universal adhesive was applied to the prepared samples using two different protocols (total etch and self-etch), and samples were then filled with bulk fill CRs. Each bulk fill CR group was polymerized with 2nd and 3rd generation LED to form subgroups (n=10). The SBS values were recorded in MPa using a universal testing device. Results: The highest SBS values were obtained for the X-tra Fil group in total etch mode with polymerization using 3rd generation LED, while the lowest SBS values were found for Filtek One Bulk Fill group in self-etch mode with polymerization using the 3rd generation LED. In all groups, total etch mode yielded higher SBS values compared to self-etch mode. Conclusion: Different adhesive protocols and LCUs were found to affect the SBS values of bulk fill CRs during repair.